How to Install Concrete Bollard Caps

Installing concrete bollard caps is a relatively simple process that can be done in a few easy steps. Here is a step-by-step guide to help you install your concrete bollard caps:

Step 1: Clean the Bollard

Before installing the bollard cap, it is important to clean the bollard thoroughly. Use a wire brush or a power washer to remove any dirt, debris or loose concrete from the surface of the bollard.

Step 2: Apply Adhesive

Once the bollard is clean and dry, apply a layer of adhesive to the top of the bollard. Make sure to use a high-quality adhesive that is designed for use with concrete.

Step 3: Place the Cap

Carefully place the concrete bollard cap onto the top of the bollard. Make sure that the cap is centered and level on the bollard. Press down firmly on the cap to ensure that it is securely attached to the bollard.

Step 4: Allow the Adhesive to Dry

After placing the cap onto the bollard, allow the adhesive to dry completely. The drying time will depend on the type of adhesive used, so be sure to follow the manufacturer's instructions.

Step 5: Seal the Cap

Once the adhesive has dried, seal the cap with a high-quality concrete sealer. This will help to protect the cap from the elements and prevent it from cracking or chipping over time.

Step 6: Repeat the Process

Repeat the process for each bollard that you need to cap. Be sure to clean each bollard thoroughly before applying the adhesive and placing the cap.

In conclusion, installing concrete bollard caps is a simple process that can be done in a few easy steps. By following these steps, you can ensure that your bollards are protected and look great for years to come.